The use of sandblasting machine, from which aspects can save abrasive?

Everyone knows that saving.sandblasting machineAbrasives are closely related to the success of production. In order to achieve faster efficiency and lower abrasive loss, it is necessary to know the data quality and specific accurate data of the user's product. Only mutual understanding can play a good role. Below is the East side machine. Next, Xiao Bian will talk to you about how to save abrasives from five aspects by using sandblasting machine.

　1. Embrittlement of burrs

The sandblasting machine uses the low temperature freezing effect of liquid nitrogen to make the rubber alloy material brittle. At this time, the burr is brittle before the product. In the time difference when the burr is brittle but the product is not brittle, a polymer particle is ejected at high speed to hit the burr of the product to remove the burr of rubber and plastic alloy products and aluminum and zinc alloy products with high quality.

　　2. Dust Collector

The sandblasting machine is adjusted to a preferred position before use.sandblasting machineIt is a machine that uses compressed air as the power to form a high-speed spray beam, so that the spray material is erupted at high speed to the appearance of the workpiece to be processed, thereby changing the mechanical properties of the appearance of the workpiece. The sandblasting machine can actively adjust the fully active sandblasting, time, interval, blowback time, spray gun movement, worktable speed, etc. through the electrical control system. Remove the filter of the vacuum cleaner (function: air purification) in time, throw away the waste sand inside in time, and reduce the amount of abrasive used to a large extent.

　3. Spray gun

Before using the sandblasting machine (structure: supply system, circulation system, etc.), check whether there is wear in the spray gun (the root type of component failure), once the dead mouth can be checked. Nozzle and other places have wear (the fundamental type of parts failure), to be replaced in time, indirectly prevent abrasive damage.

　　4. Sand pipe

Whether the sand pipe is straight is the work required for the patrol before the sandblasting machine works. Folded up, the amount of scrub will be bad a lot.

　　5. Separator

It is an important part of saving abrasives. Before buying a sandblasting machine, you should accurately tell the factory the variety of abrasives before the process is determined. In this way, the design can be well combined with the required specifications, accurate operation.

The sandblasting machine uses the low temperature freezing effect of liquid nitrogen to make the rubber alloy material brittle. At this time, burrs are embrittled before the product, and high-speed polymer particles will be ejected at the moment when the product is not brittle. The burrs of rubber and plastic alloy products and aluminum and zinc alloy products can be removed with high quality. Abrasives will naturally reduce the application measurement.

To sum up,sandblasting machineDue to the influence of the abrasive on the surface of the workpiece and the cutting effect, it provides a certain degree of cleanliness and roughness for the surface of the workpiece, and improves the mechanical properties of the surface of the workpiece. Therefore, the fatigue resistance of the workpiece is improved, the coating and adhesion are increased, and the durability of the coating is prolonged. It also helps to smooth and decorate the paint, remove impurities, noise and oxide layer on the surface, and make the surface of the medium rough.