What is the structure composition and application scope of the hook type shot blasting machine?

　　Hook type shot blasting machineIt is a kind of shot blasting machine, which is mainly used to remove the rust layer, oxide skin and welding slag on the surface of the workpiece. It has the advantages of simple structure, convenient maintenance and flexible operation, and is suitable for mass production of small and medium-sized castings and forgings. The hook shot blasting machine can be used to clean the surface of the hanging tool for painting. For the choice of this equipment: According to the actual situation of the customer, the size of the workpiece is small, and some are lighter; the paint adhesion on the surface of the workpiece is strong, and the shot peening time is generally long and the efficiency is low. The hook type shot blasting machine can be rotated during the cleaning process, and the overall surface cleaning is carried out from multiple angles at the same time. On the one hand, it can achieve a good treatment effect and greatly improve the cleaning efficiency. Secondly, the blasting effect of the hook shot blasting machine is relatively uniform, which reduces the deformation and is beneficial to the protection of the workpiece. The following describes the structure and application scope of the hook type shot blasting machine:

1.Hook type shot blasting machineIt is mainly composed of hook assembly, indexing device and separator.

1. Lifting frame: used to lift the workpiece to be cleaned from the conveyor chain and place it in the proper position of the machine cavity.

2. indexing device: It is composed of two parts: a spindle assembly and a transmission mechanism. The spindle assembly is fixed on the base; the transmission mechanism is driven by a motor through a V-belt to drive the reducer to rotate and drive the spiral gear pulley to drive the turntable to rotate to achieve indexing. Degree function.

3. Hook type shot blasting machine: Centrifugal separator: It is a part that uses the principle of centrifugal force to clean the workpiece. The centrifugal force generated when the rotor blades are running at high speed causes the rotating table to produce a large radial speed difference, and a certain difference is obtained between the centrifugal force and the axial speed, so that the workpiece can be separated from the surface of the rotating table under the action of the centrifugal force. The pollution layer is separated and thrown into the outer wall or brush cylinder of the machine.

4. The hook is made of good carbon structural steel after quenching and tempering, and is finely ground after heat treatment to remove stress. It is a special sling with high wear resistance and high toughness; it has the characteristics of high strength, high rigidity, and not easy to deform; it can effectively reduce the cost and service life of the equipment.

2.Hook type shot blasting machineScope of application:

1. It is used for polishing the surface of various metal plates (aluminum stainless steel plate, copper plate, iron plate, plastic plate, wood glass fiber reinforced material, steel plate, titanium alloy, cast iron, carbon composite material, ceramic stone mold, etc.) to remove oily oxide skin, welding slag, burr, dust and other attachments.

2. It can be used for roughening of steel surface before heat treatment.

3. Hook-type shot blasting machine: It can also be used for the pretreatment process in the anti-corrosion process after rust removal and phosphating of steel structures. It is suitable for all kinds of cold-rolled thin-walled cross-section tubes and I-shaped angle groove line parts. It is galvanized and annealed before welding, then finished and screwed. Bolt and nut lock washers, spring washers, dust covers, and various hardware products can achieve good results in the stamping process.